sweeek. RICHELIEU 3 Mode D'emploi page 28

EN
ADVICE IN CASE OF A FAILURE
PROBLEM THE CAUSE
The safety button / restart button
hasn't come on
The gas valve is closed / The gas
canister is empty
The opening or tube of the diffuser is
obstructed
There's air in the gas pipe.
The burner
doesn't light
The piezoelectric ignition isn't wor-
/ the burner
king
doesn't stay lit
A build-up of dirt around the burner
There's a loose connection between
the gas valve and the pilot light.
The gas pressure is low
The opening is obstructed
The power switch isn't set to « MAX »
or « MIN »
The gas pressure is low
The burner
flame is weak
The exterior temp. is greater than 5°C
and the tank only fills itself to 1/4
Note: Don't
The gas hose is twisted or doubled
use the ap-
over
paratus if the
exterior temp
is less than
The power switch is completely open
5°C
(« MAX » or « MIN »)
The burner
The gas pressure is low
flame isn't
uniform
The barbecue isn't on a flat surface
Note: the
lower part,
2,5cm from
There's a build-up of dirt on the
the burner
burner
doesn't nor-
mally light up
Build-up of
Dirt or film on the burner or diffuser
carbon
Thick black
The burner is obstructed
smoke
28
THE SOLUTION
Push the restart button, to start the flow
of gas.
Open the valve / Replace the gas canister
Clean the opening with a brush or a fine
paint brush
Open and purge the gas tube (keep
pushing the power switch
or until you can smell gas)
Use a match the light the pilot light. If it
lights, get a new ignition and replace the
non-working one.
Clean the burner
Tighten the connection and check to see if
there's a leak
Attach the gas cylinder again
Clean the opening
Turn the switch to « MAX »
Reconnect the gas cylinder
Reconnect the gas cylinder
Untwist the gas hose and check there is
no leak
Turn the button to « OFF », let the appa-
ratus cool down and make sure that the
burners and the holes aren't obstructed.
Reconnect the gas cylinder
Put the barbecue on a flat surface
Clean the burner
Clean the burner of the diffuser
Turn the button to « OFF », let the appa-
ratus cool-down, clear any obstructions
and clean the exterior and interior of the
apparatus
for 1-2 minutes
6/11/2023