Toshiba FST PURE COLORSTREAM 27AF43 Manuel Du Propriétaire page 12

To control a cable TV
converter:
Program the remote
control to recognize the
brand of your converter
Channel
(see "Programming the
Numbers
remote control for use
with a VCR, DVD player,
or cable TV converter"
Channel +/–
below). The buttons
shown at right will control
the cable TV converter.
CH Enter
Press the CABLE button
first.
Programming the remote control for use with
a VCR, DVD player, or cable TV converter
This remote control is pre-programmed to operate Toshiba VCRs and
DVD players. To control VCRs, DVD players, or cable converters other
than Toshiba models, you must follow the steps below to program your
remote control.
1. While holding down the CODE button, press the button for the
device you want to control (VCR, DVD, or CABLE).
2. Enter the 2-digit code listed on page 13 using the Number buttons
(0-9) within 10 seconds.
3. Point the remote control at the VCR, DVD player, or converter and
press POWER to test the code.
If the VCR, DVD player, or converter turns on, you have entered
the right code.
If the VCR, DVD player, or converter does not respond to the
remote control, you may have entered the wrong code. Repeat
steps 1-2 with another code.
For future reference, write down the codes you used:
VCR code ________________________
DVD player code ___________________
Cable TV converter code _____________
CABLE
POWER
TV VCR CABLE
Power
DVD
1 2 3
+10
4 5 6
100
7 8 9 0
CH +
VOL VOL
MENU/
– +
ENTER
CH –
EXIT RECALL TV/VIDEO FAV
VOL CH RTN FAV
RESET CAP/TEXT 16:9
1/2
DISPLAY DVD CLEAR TOP MENU DVD MENU
CODE MTS SLEEP MUTE
FF
REW PLAY
TV/VCR STOP PAUSE/STILL
REC VCR CH
DVD SKIP
Notes:
• When shipped from the factory, the remote
control is set to operate your TV.
• If you do not enter the code within 10
seconds from step 1 or if you enter a code
not listed below, this operation is canceled.
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2."
If your VCR has this kind of switch and does
not respond to any of the codes for your
VCR, set the switch to the other position
(VCR1 or VCR2) and reprogram the remote
control.
12
VCR
POWER
TV VCR CABLE
CABLE
DVD
1 2 3 DVD
+10
4 5 6 100
0
7 8 9
CH +
VOL VOL
MENU/
– +
ENTER
CH –
EXIT RECALL TV/VIDEO FAV
VOL CH RTN FAV
RESET CAP/TEXT 1/2 16:9
DISPLAY DVD CLEAR TOP MENU DVD MENU
CODE MTS SLEEP MUTE
Code
REW PLAY FF