Troubleshooting - Greencut GS200L Manuel D'utilisation

Sword
Complete saw
Chain brake
ATTENTION:
• Always use gloves when working around the blade assembly.
• Use only original spare parts for this machine.
• Clean the device with a slightly damp cloth.
REPLACEMENT OF SWORD AND SAW CHAIN
ATTENTION: Saw chain is very sharp, always use protective gloves when doing any kind of
maintenance to the chain. A dull or worn out chain can cause excessive engine speed during
cutting, which can cause severe damage to the engine. Incorrect chain sharpening increases the
potential for kickback. Failure to replace or repair a damaged chain can cause serious injury.
1. To replace the parts, follow the same assembly instructions as for the bar and chain of the chainsaw.
INSPECTION AND CLEANING OF THE CHAIN BRAKE
• Always keep the chain brake mechanism clean by lightly brushing the connections so that there is no dirt.
• Always check the operation of the chain brake after cleaning.

TROUBLESHOOTING

The table includes some of the most common problems, their causes and remedies.
PROBLEM
The battery is not installed correctly.
The ON/OFF switch is not on.
The device does
The chain brake is not set backwards.
not work.
The battery is exhausted.
The battery is defective.
The device is defective.
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service..
INSPECT AND CLEAN
Before every use
After each use
Every 5 hours*
POSSIBLE CAUSE SOLUTION
Put the battery in place.
Make sure the machine is turned on.
1. Pull the chain brake back (towards the
user).
2. Release the ON/OFF switch and the safety
lock.
3. Restart the device by pressing the ON/
OFF switch and the safety lock.
Charge the battery.
Contact the after-sales service.
67
EN