Home Decorators Collection FAWNDALE 72021 Guide D'utilisation Et D'entretien page 8

Assembly - Hanging the Fan
1
Attaching the fan to the electrical box
WARNING: To reduce the risk of fire, electric shock or
personal injury, mount to an outlet box marked "Acceptable
for fan support of 35 lbs. (15.9 kg) or less," and use the
screws provided with the outlet box.
NOTE: The mounting bracket (A) is designed to slide into
place on an outlet box with the outlet box screws (MM).
□
Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□
Install the slide-on mounting bracket (A) on the outlet box by
sliding the slide-on mounting bracket (A) over the two screws
(MM) provided with the outlet box. If necessary, use leveling
washers (not included) between the slide-on mounting bracket
(A) and the outlet box. The flat side of the slide-on mounting
bracket (A) should face toward the outlet box, as shown.
□
Securely tighten the two mounting screws (MM).
2
Hanging the fan
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly (B) into
the socket of the slide-on mounting bracket (A).
□
Turn the ball/downrod assembly clockwise until it is seated
with the tab of the slide-on mounting bracket (A) aligned with
the slot in the ball.
3
Connecting the safety cable
□
Turn a wood screw (OO) (not provided) into the ceiling.
□
Place the looped end of the safety cable (T) onto the wood
screw and then tighten the screw firmly, or connect the
safety cable directly to outer joist.
OO
T
8
A
B
C
JJ
D
E
A