Home Decorators Collection FAWNDALE 72021 Guide D'utilisation Et D'entretien page 7

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
□
Remove the canopy bottom cover (JJ) from the canopy
(C) by turning the bottom cover counterclockwise until it
unlocks.
□
Loosen the two canopy screws (HH) located in the
bottom of the mounting bracket (A), and turn the canopy
counterclockwise to remove the mounting bracket (A)
from the canopy (C).
3
Assembling the fan
WARNING: Failure to properly install the locking
pin (BB) could result in the fan becoming loose and
possibly falling.
□
Loosen, but do not remove, the setscrews (LL) on the collar on
top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (AA) through the holes in the
collar and ball/downrod assembly (B). Be careful not to jam
the hanger pin (AA) against the wiring inside the ball/downrod
assembly (B).
□
Insert the locking pin (BB) through the hole near the end of the
hanger pin (AA) until it snaps into its locked position.
□
Re-tighten the setscrews (LL) on the collar on top of the fan-
motor assembly (E).
2
□
□
□
A
HH
C
JJ
AA
7
Routing the wires
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (JJ).
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
Please contact 1-800-986-3460 for further assistance.
C
JJ
D
B
E
C
JJ
D
B
BB
LL
E
HOMEDEPOT.CA