Applications; Connecting To Power Supply; Starting And Stopping - Homelite UT43160 Manuel D'utilisation

APPLICATIONS

You may use this product for the purposes listed
below:
 Limbing
 Pruning
ADDING BAR AND CHAIN LUBRICANT
See Figure 4
Use HOMELITE Bar and Chain Lubricant. It is
designed for chains and chain oilers, and is for-
mulated to perform over a wide temperature range
with no dilution required.
NOTE: Pole saw comes from the factory with
no bar and chain oil added. Level should also be
checked after every 20 minutes of use and refilled
as needed.
 Remove oil cap.
 Carefully pour the bar and chain oil into the
tank.
 Wipe off excess oil.
 Check and fill the oil tank when quick view oil
indicator is below the second to last indicator
line.
 Repeat as needed.
NOTE: Do not use dirty, used or otherwise
contaminated oils. Damage may occur to the
bar or chain.
NOTE: It is normal for oil to seep from the saw
when not in use. To prevent seepage, empty the
oil tank after each use then run for one minute.
When storing the unit for a long period of time
(three months or longer) be sure the chain is lightly
lubricated; this will prevent rust on the chain and
bar sprocket.

CONNECTING TO POWER SUPPLY

See Figure 5.
This product is designed with a cord retainer that
prevents the extension cord from being pulled
loose while using.
 Form a loop with the end of the extension
cord.
 Insert loop portion of extension cord through
opening in the bottom of the rear handle and
place over cord retainer.
 Slowly pull loop against cord retainer until the
slack is removed.
OPERATION
QUICK VIEW
OIL INDICATOR
LOCK-OUT BUTTON
 Plug product into extension cord.
NOTE: Failure to remove all excess cord slack
from extension cord retainer could result in plug
loosening from receptacle.

STARTING AND STOPPING

See Figure 5.
To start the motor:
 Connect the pole saw to power supply.
 Place your thumb on the lock-out button and
pull it completely towards you.
 Fully depress the switch trigger.
To stop the motor:
 Release the switch trigger.
Page 12 — English
RESERVOIR
SWITCH TRIGGER
CORD RETAINER
OIL
CAP
Fig. 4
Fig. 5