Operation - Homelite UT43160 Manuel D'utilisation

CORD
CONNECTING THE POLES
See Figure 3.
Before using the pole saw, a one-time assembly is
required. When removed from the box, the three
poles are connected by an electrical cord as shown
above.
 Remove packaging material from cord and dis-
card.
 Unscrew the lower collar from the threaded base
on the intermediate pole and push back over the
cord to the handle pole shaft as shown.
 Insert the handle pole into the intermediate pole
and slide together until you hear the button click.
The tubes are egg-shaped and will only install one
way.
DANGER:
Never use near power lines or other electric
sources. Contact with power lines or electric
sources will result in death by electrocution or
serious injury.
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
ASSEMBLY
HANDLE POLE
THREADED BASE
BUTTON
UPPER COLLAR

OPERATION

Page 11 — English
LOWER COLLAR
INTERMEDIATE
POLE
POWERHEAD POLE
 Lower the collar on the handle pole to the threaded
base on the intermediate pole and rotate clock-
wise to secure.
 Repeat this process to attach the intermediate
pole to the powerhead pole.
NOTE: Once assembled correctly, handle pole and
powerhead pole should not be able to separate from
intermediate pole when pulled. Repeat above steps
if poles can be separated from intermediate pole.
WARNING:
Failure to lock powerhead pole as directed above
could result in serious injury or death.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
head protection. Failure to do so could result in
objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
BUTTON
THREADED
BASE
Fig. 3