Hilti TE 30 Mode D'emploi Original page 25

Trouble or fault
No hammering action.
The combihammer doesn't
achieve full power.
The drill bit doesn't rotate.
The drill bit can't be released.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r6848760 (TE 30) and
qr.hilti.com/r6848759 (TE 30-AVR).
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Originele handleiding
1 Informatie over de handleiding
1.1 Bij deze handleiding
• Lees voor ingebruikname deze handleiding door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze handleiding en op het product in acht
nemen.
• De handleiding altijd bij het product bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
*2143373*
Possible cause
The function selector switch is set
to "Rotary drilling only"
Contact pressure too low.
The gauge (cross section) of the
extension cord conductors is inad-
equate.
The control switch is not fully
pressed.
The tool has been set to reverse
rotation.
Voltage from generator is too low.
The function selector switch is not
engaged or is in the "Chiseling"
or "Chisel adjustment" position.
The chuck is not pulled back fully.
2143373
Action to be taken
▶ Set the function selector switch
. to the "Hammer drilling" position
.
▶ Press harder to increase contact
pressure so that hammer
mechanism cuts in.
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Press the control switch as far
as it will go.
▶ Set the tool to forward rotation.
▶ Make sure that voltage rating of
electricity supply is correct.
▶ Set the function selector switch
to "Drilling without hammering"
or "Hammer drilling"
▶ Pull the tool lock back as far
as it will go and remove the
accessory tool.
.
Nederlands 19