Husky 8210642A Guide D'utilisation Et D'entretien page 9

Care and Cleaning
WARNING: To reduce the risk of injury from accidental starting, unplug the power cord before emptying the dust tank.
□
Remove the power head assembly of the wet/dry vacuum by pulling outward on the lid clips located on each side of the vacuum. Lift off
the power head assembly.
□
Dump the tank contents into the proper waste disposal container.
CLEANING
To keep your wet/dry vacuum looking its best, clean the outside with a cloth dampened with warm water and mild soap.
To clean the tank:
□
Dump out debris.
□
Wash the tank thoroughly with warm water and mild soap.
□
Wipe with a dry cloth.
Troubleshooting
WARNING: To reduce the risk of injury from moving parts and/or electrical shock, turn power switch off and disconnect power plug
from electrical outlet before performing troubleshooting checks.
Minor problems often can be xed without calling customer service.
Problem
The vacuum does not run.
There is a loss of suction during wet
pickup.
There is a loss of suction during dry
pickup.
Possible Cause
□
No electricity.
□
The tank is full.
□
The hose is clogged.
□
The lter is clogged.
□
The tank is full.
□
The hose is clogged.
□
The lter is clogged.
9
Corrective Action
□
Make sure electrical outlet has voltage (a
quali ed electrician may need to be contacted).
□
Drain and clean the tank.
□
Remove the hose and clean out the debris.
□
Clean or replace the lter.
□
Drain and clean the tank.
□
Remove the hose and clean out the debris.
□
Clean or replace the lter.
Please contact 1-888-HD-HUSKY for further assistance.
HUSKYTOOLS.COM