Publicité
Les langues disponibles
Les langues disponibles
Assembly
WARNING: To reduce the risk of re or explosion, do not operate this vacuum in areas with ammable gases, vapors or explosive
dust in the air. Flammable gases or vapors include but are not limited to: lighter uid, solvent-type cleaners, oil-based paints, gasoline,
alcohol or aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not
vacuum explosive dust, ammable or combustible liquids or hot ashes. Do not use this vacuum as a sprayer for any ammable or
combustible liquid. To reduce the risk of health hazards from vapors or dusts, do not vacuum toxic materials.
WARNING: The operation of any utility vacuum can result in foreign objects being blown into the eyes, which can result in severe eye
damage. Always wear safety eyewear complying with ANSI Z87.1 (or in Canada, CSA Z94.3) before starting operation.
CAUTION: To reduce risk of hearing damage, wear ear protectors when using the vacuum for extended hours or when using it in a
noisy area. This 6 gallon/22.7 liter wet/dry vacuum is not fully assembled at the factory. You must install the casters and handle after
removing contents from the packaging. The unit is featured with vacuuming and blower functions. after fully assembling the vacuum,
plug the power cord into the wall receptacle, turn the unit "ON" by pushing the switch from position "O" to position "I". The "O" is the
"OFF" position and the "I" is the "ON" position.
1
Installing handle
□
Place the handle (A) in the recess.
□
Secure in place with the screws (AA).
AA
A
O = OFF
I = ON
2
Installing casters
□
Insert the casters (I) into the bottom of the
□
Strong pressure is required. Listen for the click to ensure they are
locked in place.
I
6
accessory holders (H)
.
H
Publicité
