Hobot 198 Mode D'emploi page 50

Step 1. Preparing
(1) Don't use the device on rainy or high humidity days, otherwise it will produce white streaks.
(2) For windows with no balcony, a warning area must be established on the ground below to
prevent people from coming near it.
(3) Check if the safety rope is broken or the knot is loose before operating the device.
(4) Fasten the safety rope and tie to an indoor fixture before operating the device.
(5) Do not use on frameless glass.
Step2. Assemble adaptor, DC power cord, AC power cord before plugging L-shape connector
into DC power jack on the device and then plugging AC power cord into the socket.
Step 3. Make sure the battery is fully charged (green light ON) before use:
(1) Turn off the power switch on the device and then plug it into a power source. Orange light ON
means charging.
(2) Green light ON means the battery is fully charged.
Step 4. Refer to the illustrations below. Make sure cleaning ring is perfectly covered by
cleaning cloth and put the cleaning ring onto the cleaning wheel correctly to avoid
leakage.
Step 5. How to put the device onto glass.
(1) Turn power switch on. Make sure fan is running.
(2) Put the device onto glass and keep 10cm away from the frame of window.
(3) Check if the device is sticking to the glass before releasing it.
Step 6. Auto mode and Manual mode operation.
(1) Press
(2) Press to stop the device running.
(3) Press
Step 7. Finish and remove the device from glass.
(1) While the device is running, hold the safety rope with one hand and take the device down from
glass with the other hand.
(2) Remove the device to a safe area, then turn it off.
UPS (Uninterrupted Power System) function:
(1) The UPS function will be enabled automatically when no electric power is supplied. The
backup time of this UPS is 20 minutes.
(2) If no electric power is supplied, the device will stop automatically, sound an alert, and flash a
red light. The user should take the device down from the glass as soon as possible.
(3) The safety rope can be used to pull the device back. Gently pull the safety rope at an angle
close to the glass to prevent it from falling.
or or , the device automatically cleans whole window.
to manually control the device moving.