Falcon K100 Guide De Mise En Marche page 5

Maintenance and Storage
Product Marketing Name(PMN): AQ11091W1
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference that may be received or that may
cause undesired operation. A distance of at least 20 cm. between the equipment and all persons should be maintained during the
operation of the equipment.
Cleaning the filters
The two filters must be cleaned after each cleaning cycle. Press the buton
to release the filter and pull it out of the cleaner. Open the filter case. Spray
water on the outer sides of the filter and then spray water towards the inner
side of the filter to clean all the dirt and debris. Reinsert the filter back into
its location.
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in use:
Disconnect the power cord from the wall outlet. Disconnect the floating
cable from the power supply. Make sure that the power supply is not
exposed to water Spread out the floating cable, and roll it. Wash the
cleaner unit interior space with fresh water and let it dry. Roll the floating
cable and place it on the cleaner unit. Caution: Do not roll the floating cable
on the handle of the cleaner unit. Store the robotic cleaner components in a
dry, closed location.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the propeller
of the water outlet: Remove the filters. Remove the screws that hold the
water outlet cover. Remove the water outlet cover. Clean any hairs, dirt, or
debris. Return the cover and fasten it with the screw. Reinsert the filters.
FALCON K100 / K200 ROBOTIC POOL CLEANERS
5