Falcon K100 Guide De Mise En Marche page 3

Operation
Please use as much cable as
needed. Leave the remaining
cable out of the pool.
You may turn on
the cleaner when it
reaches the floor.
3.6 m / 11.8 ft
Placement of the Power Supply
Place the power supply at least 3.6 meters / 11.8 feet from the pool
and at least 12 cm above ground. CAUTION: The power supply is
not water resistant; it must not be exposed to water or to direct
sunlight.
Press the plastic snap on the zip ties in order to release the floating
cable. Use as much cable as needed in the the water.
Before placing the cleaner unit in the water
Make sure there are no people in the pool. Make sure that the filters
are clean. Make sure the pool conditions are met; (see "Operating
Conditions" ).
Placing cleaner in the water
Unroll the floating cable. It is recommended to extend a length of
cable that is equal to the pool diagonal size plus an additional two
meters. Smooth out coils or twists in the cable. Connect the floating
cable to the socket located on the power supply. Roll extra cable, no
12 cm / 4.7 inch
above ground
in the pool, near the power supply. Place the cleaner unit in the pool.
Let it sink to the bottom of the pool. Do not start operation before the
robotic cleaner is settled on the pool floor.
CAUTION: Operating the cleaner out of water may cause
immediate and severe damage resulting in loss of warranty.
NO SWIMMING
WHILE THE ROBOT
IS IN THE POOL
FALCON K100 / K200 ROBOTIC POOL CLEANERS
3