Bosch 06032A2101 Notice Originale page 17

Material/workpiece
Flexible materials (e.g. tex-
tiles)
Note: If a new glue stick is inserted, it will push the rest of the
previous glue stick out before the new colour or material
comes out. Please take note of this fact when changing the
colour or material of the glue stick.
Do not use flammable solvents to clean the bonding loc-
u
ations. The hot glue could ignite any solvent residue or re-
lease hazardous fumes.
Adhesive residue on clothing cannot be removed.
The bonding locations can be painted.
Errors – causes and corrective measures
Problem Cause
Glue pen does Zinc-carbon batteries
not work. (R6) used.
Glue pen only op- Alkali-manganese
erates for a short batteries (LR6) used.
time
Glue stick feed is Glue pen has not fin-
sluggish. ished heating up.
Feed is too fast
Batteries are weak
Melting point of glue
stick is too high
Adhesive flows Glue stick diameter
backwards in the too small.
glue pen.
"Threads" de- Feed is still activated
velop as the glue when the application
pen is removed of adhesive is fin-
from the bonding ished.
location after ap-
Discharge nozzle has
plying adhesive.
not been wiped off.
Maintenance and Service
Maintenance and Cleaning
Warning! Switch the glue pen off before commencing
u
maintenance and cleaning work.
Keep the glue pen clean to ensure good, safe operation.
u
After the adhesive has hardened, you can remove it with a
blunt object. Do not use solvents when cleaning. If necessary,
the bonding locations can be unstuck again by applying heat.
Take particular care to keep the slider (5) and its guide clean.
Remove adhesive residue with a blunt object after it has
cooled.
Do not remove an inserted glue stick (3) out of the back of the
glue pen.
Bosch Power Tools
English | 17
Recommendation
Apply adhesive in lines
Corrective meas-
ures
Use NiMH batteries
(HR6).
Use NiMH batteries
(HR6).
Let the nozzle heat
up for 60 s.
Charge batteries
Use recommended
original glue sticks.
Use recommended
original glue sticks.
Stop the feed just
before finishing ap-
plying adhesive.
After finishing ap-
plying adhesive
wipe off the nozzle
on the workpiece.
1 609 92A 7SW | (15.06.2022)