Bosch 06032A2101 Notice Originale page 16

16 | English
Place the glue pen down in a safe place after use and let
u
it cool down completely before packing it away. The hot
nozzle can cause damage.
Working Advice
Keep people and animals away from the hot adhesive
u
and the nozzle tip. Adhesive and nozzle tip will heat up to
150 °C, posing a risk of burns. If hot adhesive comes into
contact with skin, immediately hold the affected area under
a stream of cold water for several minutes. Do not try to re-
move the hot adhesive from the skin.
Only use adhesives that have been recommended by the man-
ufacturer of the glue pen.
Only use low-temperature glue sticks (with melting points of
between 110 and 150 °C). Do not use glue sticks intended for
high gluing temperatures (170–200 °C).
Adhesive bonds can become unstuck when they are affected
by moisture.
Preparing for gluing
The bonding locations must be clean, dry and free from
grease.
The materials to be glued together and the work surface must
not be easily ignited or flammable.
Test whether heat-sensitive materials are suitable beforehand
on a sample workpiece.
The ambient temperature and the workpieces to be glued
must not be colder than +5 °C and not warmer than +50 °C.
Materials that cool the adhesive down quickly should be
warmed first with a hot air gun.
Gluing (see image A)
To open the glue stick compartment, push the slider (5) in the
direction of ➊. Insert the glue stick (3) suited to the material
in the glue stick compartment (4) ➋.
Switch the glue pen on and allow it to heat up. The light-up
ring (6) will flash slowly.
As soon as the light-up ring (6) is continuously lit up, the glue
pen is ready to use.
Move the slider (5) in direction ➌ with moderate pressure to
deliver the adhesive. If the slider hits the front end, the glue
stick (3) has been used up. Insert a new glue stick.
Apply the adhesive to one side (see "Application tips",
page 16).
Press the materials you wish to glue together against each
other for around 10 to 30 seconds immediately after applying
the adhesive. Correcting the bonding location is still possible
at this point.
The bond is stable after approx. two minutes of cooling time.
Make sure you do not come into contact with the hot ad-
u
hesive. Use a silicone mat to press permeable materials to-
gether.
Application tips
Material/workpiece
Long workpieces with large
surface areas
1 609 92A 7SW | (15.06.2022)
Recommendation
Apply adhesive in dots
Bosch Power Tools