Connection Diagram - Alesis DM8 Guide D'utilisation Rapide

CONNECTION DIAGRAM

DRUM KIT
WARNING: Use only the
included Alesis power supply
with the DM8 module.
HOUSE AMP
•
Connect the 1/4" cables of your kit's cable snake to the drum pads and cymbal pads of your kit. Each cable is labeled
with its proper trigger.
•
If you have additional drum pads, cymbal pads, or other triggers, you can use standard 1/4" cables to connect them to
the "RIDE 2/PERC1" or "PERC2" TRIGGER INPUTS on the module's rear panel. Dual-zone pads or cymbals (e.g., a
drum with head and rim triggers or a cymbal that can produce bow and bell sounds) will require TRS cables to trigger
both zones.
•
Plug 1/4" TRS cables from the MAIN OUT to an amplifier, mixer, or speaker system. (For mono sound, connect a cable
to the Left output.)
•
You can connect a set of 1/4" TRS headphones to the PHONES output.
•
You can connect another audio device to the AUX IN using a standard 1/8" stereo cable.
See the included assembly poster for further instructions on setting up the DM8 Kit and connecting it to the DM8 module.
NOTE: Out of the box, the DM8 module is write-protected, so you will be unable to save any changes you make to the Kits,
Instruments, Sequences, etc. To turn write protection off:
1. Press UTILITY.
2. Press SYS (F4).
3. Press O/S (F3).
4. Press MEM (F4).
5. Press VALUE DOWN or move the VALUE DIAL counterclockwise until the "WriteProt" field says "OFF."
6. Press DRUM KIT to return to the main page.
IMPORTANT: THE DM8 MODULE MAY BE AFFECTED BY STATIC ELECTRICITY. IF THIS OCCURS, SIMPLY TURN
THE MODULE OFF AND WAIT AT LEAST A FEW SECONDS BEFORE TURNING IT ON AGAIN.
HEADPHONES
* iTunes and iPod are trademarks of Apple, Inc., registered in the U.S.A. and other countries.
iPod*
m1
m2
volume
Headphones, iPod*, keyboard, amp, and computer not included.
3
MIDI KEYBOARD
- octave +
push
tap accomp store
pitch x y z
phrase latch
a n a l o g
POWER
COMPUTER
m o d e l i n g s y n t h