Publicité
Les langues disponibles
Les langues disponibles
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the job.
This may significantly reduce the exposure level over the
total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
The power tool is intended for sawing and remodelling
wooden materials, plastic, plaster, non-ferrous metals
and fasteners (e.g. nails and clamps) as well as for
working on soft wall tiles and for dry grinding of small
surfaces. It is especially suitable for working close to
edges and for flush cutting.
ASSEMBLY AND OPERATION
Action
Mounting accessories
Mounting the sanding sheet
Operating the on/off switch
Using the variable speed dial
Remove or install battery pack
LED Light
The Variable Speed Dial can be used to set the optimum
oscillating frequency according to the accessories used
and the respective application.
Oscillating Tool
Figure
See Fig. A-C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
See Fig. H
Oscillation frequency
Sanding, Sawing, Rasping
High oscillation
and Polishing Stone and
frequency:
Metal.
Low oscillation
Scraping, Polishing
frequency:
Varnishes.
Application
EN
9
Publicité
