Télécharger Imprimer la page

Yamaha MA-190 Mode D'emploi page 23

Masquer les pouces Voir aussi pour MA-190:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
3) Quickly pull out the starter cable and then
let it slowly wind up again.
The engine has a fixed throttle setting.
Speed control is therefore not possible.
b) With throttle remote control
1) Throttle to
position (start)
2) Press the primer button 3x at intervals of
approx. 2 seconds.
At temperatures below 10 °C press the primer
button 5x.
If the engine is warm, do not press the
primer button!
3) Pull the engine brake handle towards the up-
per handle and hold in position – the engine bra-
ke handle does not lock into position.
4) Quickly pull out the starter cable and then
let it slowly wind up again.
As soon as the engine is running, position the
throttle between
according to the desired engine speed.
Starting the engine electrically
5) Throttle to
position (start)
6) Press the primer button 3x at intervals of ap-
prox. 2 seconds.
At temperatures below 10 °C press the primer
button 5x.
If the engine is warm, do not press the
primer button!
7) Pull the engine brake handle towards the
upper handle and hold in position – the engine
brake handle does not lock into position.
8) Turn the ignition key in the ignition lock all the
way to the right – when the engine is running,
release the ignition key.
The ignition key moves back to position "0".
Position the throttle between
(stop) according to the desired engine
speed.
Switching on the wheel drive
Applies only to units with a wheel drive!
Do not engage the gears while the engine is
at a standstill!
9) Press the gear switch lever against the upper
handle and keep hold – the gear switch lever
does not lock into position.
Driving speed: approx. 3,7 km/h
(start) and
(stop)
(start) and
Switching off the wheel drive
10) Release the gear switch lever.
Switching off the motor
11) push the throttle to position
12) Release the engine brake handle.
When the motor has been switched
off, the cutter continues running for
several seconds – therefore do not
touch the underside of the mower un-
til the cutter has come to a standstill!
Setting the cutting height
All wheels must be at the same height!
Speed advancing variator (VV)
On lawn mowers with VVmark you have the
possibility to change the advancing speed from
2,5 to 5 Km/h. This advancing speed can be
modified only when engine is working. In order
to do it you have to start the left-hand lever on
the operating panel. The tortoise symbol on the
operating panel means slow, the hare symbol
means fast.
3-speed transmission (3V)
Models marked with the 3V symbol have
transmission that makes it possible to choose
between 3 different advancing speeds:
1st speed - 2.5 km/h
2nd speed – 3.5 km/h
3rd speed – 4.5 km/h
The advancing speed can only be changed
while the engine is running. To do this, you
must activate the left-hand lever, located on the
operating panel, setting it to the desired speed.
Brake blade (BBC)
Lawn mowers with BBC mark have the pos-
sibility to start and stop the blade keeping the
engine working. In order to make the blade
starting, you have to draw lever toward the
handle and push lever 2 down.To stop it you
have to release the lever.
Attention: the blade needs same se-
conds to stop.
English
(stop).
en-6

Publicité

loading

Ce manuel est également adapté pour:

Ylm-53asYlm-53