SW-Motech KFT.22.995.65100/B Instructions De Montage page 57

4
Use a suitable tool to mark the two drilling points on the back of the license
plate holder (Orig.).
Then loosen the screw (4) and remove the license plate holder from the
vehicle.
 WARNING: Risk of injury!
Drill two 1/4" holes through the license plate holder at the two marks. Then
deburr the bore edges.
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
7
Errors and omissions excepted
Subject to technical and design changes.