Publicité
Les langues disponibles
Les langues disponibles
Body of spa:
1.
Water filling of water tank body: water should be filled to a position 20mm higher than the water line. If lower,
heating may not be realized. If higher, water may spill over the tank in use.
2.
Maintenance of water in the water tank body
2.1 Water in the water tank body should be filtered at fixed time regularly. It is not suggested to filter the
water at all times.
2.2 Water in the water tank body should be treated with chemical agents periodically. However, chemical
agents with calcium ions must not be used. If chemical agents with calcium ions are used for water
treatment, there will be very likely to form scales on the walls of water tank and inner heating pipes.
Water scales will directly damage the inner electrical components inside the control cabinet and further
affect the service life of control cabinet.
2.3 If the filtration system has worked for 168 hours, the system will emit a warning tone to remind the user
to clean or replace the filter element.
3. Conservation of SPA
Drain off the water inside the water tank completely and wipe off droplets of water on the walls. After that, lay
aside the SPA for 24 hours, exhaust the air and fold. If it is Winter, please fold the SPA indoors. Because outside
temperature in Winter is very low and materials may become hard. In that case, folding the materials may result
in breakage. Put the SPA inside the packing case after folding it well and then put the case in a shaded place to
avoid direct sunlight.
42
2019
2019-2020
Publicité
