Publicité
Les langues disponibles
Les langues disponibles
WARNING1:
The appliance should be supplied through a residual current device (RCD) with a rated
tripping current not exceeding 30 mA.
WARNING2:
Electric installations should fulfill the requirements of local standards. Earthed appliances
must be permanently connected to fixed wiring
WARNING3:
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
a similarly qualified person in order to avoid a hazard. Replace damage cord immediately.
WARNING4:
Parts containing live parts, except parts supplied with safety extra-low voltage not exceeding
12 V, must be inaccessible to a person in the bath.
WARNING5:
To reduce the risk of electric shock, do not use extension cord to connect unit to electric
supply; provide a properly located receptacle.
WARNING6:
Parts incorporating electrical components,
located or fixed so that they cannot fall into the bath.
WARNING7:
To avoid electric shock, do not use the spa when it is raining.
WARNING8:
Never operate the spa if the suction fittings are broken or missing. Never replace a suction
fitting with one rated less than the flow rate marked on the original suction fitting.
WARNING9:
To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised at all times.
WARNING10:
Water attracts children. Always have the spa locked with its cover after each use.
WARNING11:
When the jet function is going to be used, make sure the cover of spa is opened first.
WARNING12:
Do not switch on if there is any possibility that the water in the spa is frozen.
WARNING13:
Risk of electric shock. Never operate any electrical appliance when in the spa or when your
body is wet. Never place any electric appliance, such as a light, telephone, radio, or television,
within 5 feet (1.5m)of a spa.
WARNING14:
Pets should be kept away from spa to avoid damage.
WARNING15:
Risk of electric shock. Install at least 5 feet (1.5m) from all metal surfaces. As an alternative, a
spa may be installed within 5 feet of metal surfaces if each metal surface is permanently
connected by a minimum 1.0 mm
IMPORTANT SAFETY INSTRUCTIONS
2
except for remote control devices, must be
solid copper conductor to the wire connector on the
31
2019
2019-2020
Publicité
