EUROM Ambiance 1500 Manuel D'utilisation page 21


Attach the fully mounted suspension
bracket to the device. To that end, put
the round parts of the suspension
bracket in between the bracket of the
device. Screw and tighten both sides
using the large screws, nuts and
washers (included in the delivery)
through the large holes (see the
illustration).

Pay attention to the mounting place for
your heater. The appliance has to be
mounted on
foundation. That foundation has to be vibrationfree, exact vertical and stable
enough for lastingly holding the appliance free of problems. Check or the provided
(anchor bolts) are suitable, strong enough and qualified for the foundation. The
material provided is identified for a brick wall; for another foundation please ask
the specialist for suitable material.

Check before mounting or the minimum safe mounting distances between heater
and environment are strictly followed. The distance between the bottom edge of
the appliance and the floor must be at least 1,8 meter. There must be a distance
of at least 0,5 meter between the appliance and the ceiling, roof or other cover.
There must be a distance of at least 1,5 meter at each side between the appliance
and walls or the like. When you install the appliance outside, pay attention that it
doesn't catch excessive wind load.

Attach the Ambiance to the wall. The Ambiance can be attached to the wall in two
ways:
A. Semi-permanently by means of the wall support
B. Permanently by attaching it directly to the wall
A. Attaching to the wall using the wall support:
Attach the wall support horizontally to the wall using the four (4) cotter bolts
-
included in the delivery.
Hang the terrace radiator in the wall support
-
using the suspension bracket. Slide the
suspension bracket as far as possible through
the wall bracket so that the small hole in the
suspension bracket winds up under the wall
support. Secure the terrace radiator by
turning the wing nut (included in the
delivery) as far as possible in the small hole
of the suspension bracket (see the
illustration).
B. Directly attaching to the wall:
Attach the suspension bracket horizontally to
-
the wall using the four (4) cotter bolts.
an incombustible
21