Chal-tec Nels Pro Manuel D'utilisation page 32

EN
32
BABY CAR SEAT INSTALLATION
I Rearward facing 40-105 cm ISOFIX
+top tether + harness
1. Hold the angle and rotate the adjusting handle (12), then rotate the seat to
the car's Rear, the child seat is in reverse mode, facing back.
2. Pull the seat Angle and rotate the adjusting handle (11) to adjust the seat
to maximum inclined position.
Notes:
1. When the child seat is installed Rearwards: it has only one gear that can be
adjusted.
2. The child seat can be rotated directly when it is in the forward/rearward
position.
ISOFIX installation in the vehicle seat
1. If your car is not equipped with ISOFIX plug-
inguide sleeve (17), please use the two ISOFIX
plug-in guide sleeve (17) equipped with this seat
to clip the ISOFIX fixed point J of the car with the
notch facing upwards (as shown in the picture).
2. Hold down ISOFIX lock button (14) and ISOFIX
lock release button (15), and pull ISOFIX (16) to
the end position.
3. The left and right ISOFIX (16) buckle to the ISOFIX fixed point J of the car,
From birth
to 3 years
J