Publicité
Les langues disponibles
Les langues disponibles
8871626
surface being cleared. Surfaces with larger gravel or stones require a
higher shave plate setting.
3.
Move the snowblower to a solid, smooth, and level surface.
4.
Place a spacer board on the ground underneath the auger shave plate
between the skid shoes. The thickness of the board should be the same as
the height above the ground you wish to raise the auger shave plate. The
skid shoes should not touch the board.
5.
With the two (2) nuts loose allow the skid shoe to slide to the ground then
tighten the nuts to secure the skid shoe.
OPERATION
WARNING! Do not place any body part in the chute or auger housing when the
engine is running or control handles are engaged, even if you do not see the
auger or impeller rotating. The auger and impeller rotate at fast speeds which
can cause harm or amputation. Shut the engine off, disengage all control
handles and use the clean-out tool to remove obstructions.
Consult the separate engine manual for instructions on preparation
and operation.
PREPARATION BEFORE EACH USE
1.
Consult the separate engine manual for instructions on preparation
and operation.
2.
Check all fasteners are tight.
3.
Check the tires are properly inflated.
4.
Adjust the shave plate for the surface.
AUGER AND DRIVE CONTROLS
1.
Press down on the auger control handle
(left side handle) (Fig. 5-1) to engage the
auger.
2.
Press down on the drive control handle
(right side handle) (Fig. 5-2) to engage
the drive. The machine will start moving
in the direction and speed set with the
speed control lever.
3.
Release the auger control handle and
the drive control handle when you
8
28 in. Gas Snow Thrower
For technical questions call 1-800-665-8685
V1.0
5-2
5-1
Fig. 5
Publicité
