Publicité
Les langues disponibles
Les langues disponibles
V1.0
CLEARING A CLOGGED SNOWBLOWER
Stop the engine and disengage all control levers if snow
clogs the discharge chute or augur housing. Wait for the
blades to stop rotating. Clean out the clog with the clean-
out tool (H).
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool clean, dry and free from oil/grease at all times.
6.
Check the tightness of bolt and nuts on a regular basis.
7.
Maintain the tool' s labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
SHAVE PLATE REPLACEMENT
Remove both skid shoes and hardware, including carriage bolts and nuts,
which attach shave plate to snowblower housing. Reassemble new shave plate,
making sure heads of the carriage bolts are to the inside of the auger housing.
See Assembly and Installation.
AUGER SHEAR PINS REPLACEMENT
NOTICE! Never replace the shear pins with standard pins or fasteners. Damage
may occur to the snow blower and drive systems.
Shear pins attach the auger shaft to the auger blades. A clog or jam in the
augers may cause one or multiple shear pins to break. The shear pins are a
safety mechanism and designed to break under high load or impact to protect
the auger drive system from damage.
Replacement shear pins and nylon locknuts are provided with your
snowblower.
Visit www.princessauto.com for more information
28 in. Gas Snow Thrower
8871626
Fig. 8
11
Publicité
