CrownWall PRO Serie Instructions D'assemblage page 11

CrownWall
®
PRO Series Cabinets
STEP 6: Installing The Handles
Ensure that you use the correct handles with the correct cabinets. Please note the
following:
• 2 Door Wall Cabinet uses: 2 x handles 11-13/16" (302 mm)
• 2 Door Base Cabinet uses: 2 x handles 22-13/16" (580 mm)
• 5 Drawer Base Cabinet uses: 5 x handles 20-1/2" (520 mm)
• 2 Door Tall Cabinet uses: 2 x handles 67-7/8" (1724 mm)
1) All handles are supplied with the mounting screws in place. Loosen the screws with a
few turns using a star screwdriver (do not completely remove).
2) All cabinet doors feature "key hole" openings with one part of the hole larger then the
other. Insert the handles with loosened screws through the larger portion of the holes,
then slide over to the smaller side of the hole. Then tighten the handles in place from
the inside of the door or drawer (ensure that the washers are on the inside of the
cabinet door or drawer).
USE A SCREWDRIVER - DO NOT USE A POWERED DRILL
9