About Remaining Battery Indicator - Metabo HPT DH 36DMA Instructions De Sécurité Et Mode D'emploi

English
CAUTION
When removing the center pin and the guide
plate, turn OFF the switch and pull out the
battery.
3. Dismounting (Fig. 28)
Remove the core bit shank from the rotary hammer
and strike the head of the core bit shank strongly two
or three times with a manual hammer holding the core
bit, then the thread becomes loose and the core bit
can be removed.
Core bit
shank

ABOUT REMAINING BATTERY INDICATOR

You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light the
indicator lamp. (Fig. 29, Table 6)
The indicator will shut off approximately 3 seconds after
the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as a
guide since there are slight diff erences such as ambient
temperature and the condition of the battery.
Also, the remaining battery indicator may vary from those
equipped to a tool or charger.
State of lamp
Lights ;
The battery remaining power is
over 75%
Lights ;
The battery remaining power is
50% – 75%.
18
Fig. 27
Fig. 28
Table 6
Battery Remaining Power
Lights ;
The battery remaining power is
25% – 50%.
Lights ;
The battery remaining power is less
than 25%
Blinks ;
The battery remaining power is
nearly empty. Recharge the battery
soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully cool
down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be
the battery so please contact your
dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and battery
characteristics, read it as a reference.
Remaining battery
indicator lamp
Display panel
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
REACTIVE FORCE CONTROL
This product is equipped with a Reactive Force Control
(RFC) feature that reduces jerking of the tool body.
If the tool bit is suddenly overburdened, any jerking of the
tool body is reduced by activation of the slip clutch or by
stopping of the motor by the sensor built into the tool body.
If the motor is stopped because of overburdening detection
by the controller, the RFC indicator lamp will blink while the
switch is pulled.
Remaining battery
indicator switch
Fig. 29