OVE SHELBY 36 667455 Mode D'emploi page 13

1-2. Install the glass panel's bracket (O) and the support bar's anchor (M) onto the support bar (N1).
3. Mark the outline of the support bar's anchor (M).
4. Completely remove the support bar (N1). Place the support bar's anchor (M) back on it's wall mark, and
mark the position of it's center hole.
5. Drill a hole on the center marks with a ø6mm (1/4in) drill bit.
6-7. Insert the wall anchors (FF) using a rubber mallet. Fix the center fitting on the support bar's anchor (M)
using the screw (DD).
8-9. Install again the support bar (N1) onto the fixed glass panel (L) and support bar anchor (M). Strongly
tighten the bolts using Allen key.
1
N1
O
L
3
5
Φ 6mm
1/4in
7
DD
SUPPORT BAR INSTALLATION
O
8
N1
L
13
2
N1
M
4
M
6
FF
9