Desoutter DR300-T20000 Mode D'emploi page 7

English
A TOOl DESCRIPTION
1 Locker
2 Safety lever
3 Valve
● Hold the tool by means of the handle and
apply to the fastener to be tightened.
● Push the locker and press the safety lever to
run the tool.
MAINTENANCE INSTRUCTIONS
Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task:
- disconnect the tool.
Overhaul and preventive maintenance is
recommended at regular intervals once
per year or after maximum 1,000 hours of
use depending on which occurs sooner.
Assembly and disassembly
● Never connect a partly assembled
tool to the air supply.
Warning
The rotor blades in this tool have a
PTFE content. The normal health and
safety recommendations concerning
PTFE must be observed when handling
these rotor blades.
● Do not smoke.
● Wash hands before commencing
any other activity.
Motor components must be washed
with cleaning fluid and not blown clear
with an air line.
The silencer must be replaced when
dirty. Do not clean and re-use.
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
● Follow standard engineering practices and
refer to figures/exploded view for the mounting
of component subassemblies.
● Prior to putting the equipment back into
service, check that its main settings have not
been modified and that the safety devices
work properly.
02/2018
Meaning of the pictograms
Left hand thread
When reassembling, apply the
recommended glue
When reassembling, tighten to the
required torque
When reassembling, lubricate with the
required grease or oil.
lubrication
This tool is fitted with blades which can
operate without lubricated air. However,
a small amount of oil allows the tool to
provide full power and lengthens its life.
The use of dry air with no trace of oil
may reduce the life of blades.
If lubrication is required, an air line lubricator
should be fitted down stream of the filter.
● Use ISO VG 15.
Note: full power is achieved using a lubricated air
supply.
● Do not apply too much grease on gears or
bearings; a thin coat shall be sufficient.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www. desouttertools.com" to find out
where you can recycle this product.
7 / 48
6159922370_03