Xiaomi Mi A3 Mode D'emploi page 7

Les langues disponibles

During SAR testing, this device was set to transmit at its highest certiﬁed power

level in all tested frequency bands, and placed in positions that simulate RF

exposure in usage against the head with no separation, and near the body with the

separation of 5 mm.

SAR compliance for body operation is based on a separation distance of 5 mm

between the unit and the human body. Carry this device at least 5 mm away from

your body to ensure RF exposure level compliant or lower to the reported level. To

support body operation, choose the belt clips or holsters, which do not contain

metallic components, to maintain a separation of 5 mm between this device and

your body. RF exposure compliance with any body accessory, which contains metal,

was not tested and certiﬁed, and use such body-worn accessory should be avoided.

Legal Information

This device may be operated in all member states of the EU.

Observe national and local regulations where the device is used.

This device is restricted to indoor use only when operating in 5150 to 5350Mhz

frequency range in following countries:

Receiver Category 2

Ensure the power adapter used meets the requirements of Clause 2.5 in

IEC60950-1/EN60950-1 and has been tested and approved according to national or

local standards.

Frequency Bands and Power

This mobile phone oﬀers the following frequency bands in EU areas only and

maximum radio-frequency power:

GSM 900: 35 dBm

GSM 1800: 32 dBm

UMTS band 1/8: 25 dBm

LTE band 1/3/7/8/20/28/38/40: 25.7 dBm

Bluetooth: 20 dBm

Wi-Fi 2.4 GHz band: 20 dBm

Wi-Fi 5 GHz: 5150~5350MHz: 20dBm, 5470~5725MHz: 20dBm, 5725~5825MHz: 14dBm

FCC Regulations

This mobile phone complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including interference

that may cause undesired operation.

This mobile phone has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation.