D-Link DBA-3620P Guide D'installation Rapide page 3

Interfaces
ANT***
LAN (PoE)*
CONSOLE
Figure 2. DBA-3620P Rear Panel
* DBA-3620P can be powered via PoE from LAN (PoE)
** A manual reboot is needed when switching from internal
to external antennas, and vice versa.
*** (Optional) RP-SMA connectors for external 2.4/5 GHz
dual-band antennas.
*** For external antennas, the toggle switch must be
switched to EXT ANT.
Configuring the Access Point
Using D-Link Nuclias
Note: To use D-Link Nuclias, the DBA-3620P must be
connected to the Internet.
The DBA-3620P is designed to be managed through
D-Link Nuclias Cloud. Refer to the D-Link Nuclias User
Manual for detailed configuration instructions.
D-Link Nuclias
Switch or Router
DBA-3620P
DBA-3620P
Figure 3: Connecting through D-Link Nuclias
1. On an Internet-connected PC, open a web browser
and go to www.nuclias.com.
DBA-1510P
2. Enter your D-Link Nuclias user name and password.
Manual Configuration
Switch or Router
DBA-1510P Note: D-Link recommends manually configuring the
device before mounting it.
If you are unable to connect to D-Link Nuclias Cloud,
you may need to manually configure the DBA-3620P
using its web user interface (UI). Refer to the D-Link
DBA-1510P
ANT***
Reset Button
Toggle switch
for internal
or exernal
antennas**
Switch or Router
Management
Computer
Management
Management
Management
D-Link DBA-1510P Quick Install Guide
NucliasUser Manual for detailed configuration
instructions.
Use one of the following methods to access the
web user interface:
Connecting through Ethernet
Note: The management PC must be in the same
subnet as the DBA-3620P.
1. Use an Ethernet cable to connect the
DBA-3620P to the management PC or to
the switch or router the management PC is
connected to.
2. Open a web browser and type in the default
host name of the DBA-3620P and press Enter.
The default host name is DBA-3620P-XXXX
where XXXX represents the last 4 characters
of the MAC address listed on the device label
located on the bottom of the device.
3. When prompted, enter the default login
credentials:
User name: admin
Password: admin
Connecting Wirelessly
1. Connect the management PC to the
default SSID of the DBA-3620P. The
SSID will be in the format DBA-3620P-
XXX where XXXX represents the last 4
characters of the MAC address listed on
the device label located on the bottom of
the device.
2. O p e n a w e b b r o w s e r a n d t y p e
i n t h e d e f a u l t h o s t n a m e o f t h e
D B A - 3 6 2 0 P a n d p r e s s E n t e r .
The default host name is DBA-3620P-
XXXX where XXXX represents the last 4
characters of the MAC address listed on
the device label located on the bottom of
the device.
3. When prompted, enter the default login
credentials:
User name: admin
Password: admin
D-Link DBA-3620P Quick Installation Guide  3