Insignia NS-27LCD Guide De L'utilisateur page 8

Connecting speakers
To connect speakers to your TV:
1 Unplug the TV power cord and all devices
connected to your TV.
2 Connect the speakers to the speaker jacks
on the back of your TV. Make sure that you
connect the black part of the speaker wire to
the – jack and the red part of the speaker
wire to the + jack on the back of your TV.
Note
The location of the speaker jacks on your TV may
vary from the illustration.
Connecting an outside antenna
Antenna cables come in two types: 75 ohm and
300 ohm.
75 ohm cable
300-ohm cable
If your antenna cable has a 75 ohm connector,
connect the cable to the coaxial jack on the back
of your TV.
If your antenna cable has a 300 ohm connector,
connect the cable to a 300-75 ohm adapter (not
included), connect the adapter to a 75 ohm
cable, then connect the other end of the 75 ohm
connector to the coaxial jack on the back of your
TV.
8
Red Black Black Red
Antenna
cable
Right speaker Left speaker
Connecting cable TV
www.insignia-products.com
Insignia NS-27LCD 27" LCD TV
Use the following illustration to connect an
outside antenna.
Combination antenna
VHF/UHF
antenna
OR
75-ohm
300-ohm cable
cable
with adapter
UHF
antenna
Combiner
OUT IN
OR
Your TV has a 75 ohm jack for connecting cable
TV.
Some cable TV providers scramble the signals
for "premium" (pay) channels. To view these
channels you need a converter/descrambler box.
If you do not have a converter/descrambler box,
you can connect your cable TV directly to your
TV. If you have a converter/descrambler box, you
can connect your cable TV using an RF switch
(not supplied). For more information about
connecting a converter/descramble box, contact
your cable TV provider.
To connect cable TV without a
converter/descrambler box:
1 Connect one end of a 75 ohm cable to the
coaxial jack on the back of your TV.
2 Connect the other end of the cable to the
cable TV wall outlet.
VHF/UHF
antenna
Separate antennas
VHF
antenna