EuroLite LED ML-56 RGB Mode D'emploi page 22

Manual Mode
Set DIP switch 8, 9, 10 to ON. Now, you can control the LED´s brightness via the DIP siwtches.
DIP 1 and 2 control red
DIP 3 and 4 control green
DIP 5 and 6 control blue
Master/Slave-operation
The master/slave-operation enables that up to 16 devices can be synchronized and controlled by one
master-device.
On the rear of the ML-56 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can be
used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
In order to select Master/Slave Mode, set dip switch 10 at the Master device to ON.
Via Dips 1 - 9 you can choose all Stand-Alone funtions.
You do not have to set a DMX starting address at the Slave devices. However, Dip 10 has to be set to OFF.
DMX-CONTROLLED OPERATION
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing the device
Each device occupies 7 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
22/46 00029367.DOC, Version 1.3