Publicité
Regulatory Information
This monitor is equipped with a function for saving energy which supports the VESA Display
Power Management Signaling (DPMS) standard. This means that the monitor must be
connected to a computer which supports VESA DPMS to fulfill the requirements in the NUTEK
specification 803299/94. Time settings are adjusted from the system unit by software.
NUTEK
Normal operation
Power Saving
Alternative2
One Step
A
s an
meets the
We recommend you switch off the monitor when it is not in use for quite a long time.
Federal Communications Commission (FCC) Notice (U.S. Only)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
file:///D|/EDFU/crt_19_5/edoc/french/109E/SAFETY/REGS/REGULAT.HTM (8 of 17)2005-01-27 ¤U¤È 02:52:47
VESA State
LED Indicator
ON (Active)
Green
OFF (Sleep)
Flashing Green
Switch Off
Off
®
E
S
P
NERGY
TAR
artner,
E
S
NERGY
TAR
RETURN TO TOP OF THE PAGE
PHILIPS
109E5*
PHILIPS
has determined that this product
®
guidelines for energy efficiency.
Power Consumption
Typical 65W
< 1W
< 1W
Publicité
