Suncast Design Brilliant BMS6282 Instructions D'assemblage page 12

Assembly Walls
( continued)
En
Align tabs on bottom right side panel (C) with slots
on floor (A). Lower panel into slots.
Tilt right panel (C) outward.
MI
Lock side panel (C) by sliding panel toward rear of
floor panel (front corner tab will slide over floor and
into position).
7
Note: Use a rubber mallet to 'push' right side panel
(C) into locked position.
LB
At an angle, align tabs on side of right back panel
(D) with slots on right side panel (C). Slide back
right back panel in and down into right side panel
to secure.
12