iPower PWF3400KH Manuel Du Propriétaire Et Instructions page 14

SET UP
General Information
Fuel Use fresh high-quality unleaded gasoline (minimum 87 octane),
containing up to 10% ethanol.
Do not use fuel with high ethanol content; E15 or E85.
Oil Engine oil: Use only SAE 1 0W-30, 0.6 Quart non-detergent oil
(supplied).
Pump Oil: The pump was lubricated and sealed at the factory, and is
maintenance free for the life of the product, under normal operation. Do
not attempt to change or add oil to the pump. If the pump is leaking oil,
please call our customer service department at 1-855-888-3598.
Water Use only cold water.
Do not operate pressure washer with clogged or missing water inlet filter
screen.
Do not operate pressure washer without adequate water supply.
Pressure Pressure setting is pre-set at factory.
Adjustment For lowering pressure, refer to "Pressure Adjustment" on Page 18.
There are no serviceable parts to the high-pressure pump. Do not
High Pressure
attempt to repair or service the pump, as you may damage it and void
Pump
your warranty. If you feel that the pump needs service, please call our
customer service department at 1-855-888-3598.
Do not allow water to freeze in pump. If product is stored in an area
that will have temperatures of below 32° F, 0°C, make sure all water is
removed from the pump, or a suitable pump protection product has been
used. Failure to protect the pump form cold temperatures will cause
damage and possibly void your warranty.
By-pass When you release the trigger of the gun, the pump goes into bypass
Mode mode. It is good practice to never let the pump run in bypass mode for
more than 2 minutes. Damage to pump could be possible.
Thermal Pump is equipped with a thermal relief valve. If during bypass mode the
Relief Valve water overheats, this valve opens releasing the hot water and letting
new cool water enter the pump. Afterwards, the valve closes returning
pump to normal operation. Caution, the valve opens with no warning,
and the water will be hot. Possible injury can occur. Always keep hands
and feet away from thermal relief valve.
High Pressure Do not allow hoses to come in contact with engine muffler during use or
Hose immediately after use.
DO NOT attempt to move unit by pulling on high-pressure hose.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
12