Publicité
Les langues disponibles
Les langues disponibles
SET UP
7. Remove the protective cap on the wand
inlet. Insert the wand into the spray gun
tip and tighten the nut firmly by hand.
See Figure G.
8. Attach the nozzle to the wand by
pulling back the quick connect collar
and pushing the nozzle onto the end of
the wand. Make sure the quick connect
collar locks the nozzle in place.
See Figure H.
Figure G
Wand
Spray gun tip
Figure H
Nozzle
Quick connect
collar
Wand
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
9. Connect the water supply hose to the
water inlet connection on the Pump and
tighten the Inlet fitting firmly by hand.
See Figure I.
The water source must be able to
provide a minimum of five gallons of
clean, cold water per minute at 20PSI.
Only use a 5/8" inner diameter, or larger
hose that is rated to meet this capacity.
11
Figure I
Publicité
