LENCO DIR-250BK Mode D'emploi page 27

Manual Configuration
●
You can choose DHCP (which assigns the IP address automatically) or enter the IP address by
yourself.
When you select manual setting for wired connection, the following to be entered:
1. SSID (the name of Access Point);
2. IP Address;
3. Subnet Mask;
4. Default Gateway;
5. Preferred DNS Server;
6. Alternate DNS Server.
You may choose (Manage) specific network if you have setup more than one network
connection within an area.
Check Network when Power On
●
Enable/disable WiFi or wired network.
When you enable the WiFi network, the system will automatically search the available
AP. Select you required AP.
OK WEP or WPA code to connect the WIFI.
if the wireless network connection is not existed or failed, the icon at the top left corner
will have a cross on it. When you enable the wired network, the system will make a
connection check.
Setup PIN for App
●
Enable or disable the PIN for App, when enabled, "237992" will prompt you.
27