Publicité
Les langues disponibles
Les langues disponibles
LD-5010
14
Access Panel
Make all connections before installing access panel.
Install access panel brackets
to wall using #10 fasteners
A
(supplied by installer) as
shown in rough in drawing.
Install top screw into slot. Do
not install bottom screw until
Step C is complete.
Insert #10 thumbscrews
into front bowl apron as
B
shown. Thumbscrew in
vertical position is closed.
Thumbscrew in horizontal
position is open.
Hang access panel onto
mounting brackets attached
to wall on the left and right
sides. Rotate panel up
C
and check fitup between
thumbscrews and panel slots.
Rotate access panel down
and make adjustment to
brackets if necessary. Install
bottom #10 fastener into
brackets.
D
Attach P-trap to drain adapter
and waste outlet.
E
Plug the grounding wire
assembly adapter from
WashBar to wall outlet.
Plug dryer power cord
from dryer motor into
GFCI protected wall outlet.
F
WashBar LEDs will light up
blue. Wait 5 seconds. Place
hands under soap dispenser,
water and dryer to be sure
all 3 functions work properly.
Check for water leaks.
Rotate access panel up
G
and secure by rotating
thumbscrews to the closed
position.
To open access panel, rotate
H
thumb screw, slightly push
panel up and swing access
panel down. Do not remove
thumbscrews.
22
CAUTION For applications where children are present or for applications
subject to vandalism, order security screw option S45-2880.
#10
Thumb
Screw
#10 Top
Screw
11/21/2019
Shown in closed
position. Rotate
90° to Open
Information
label
Bradley • 215-1869 Rev. E: ECO 19-11-006
Installation
Publicité
