Publicité
Les langues disponibles
Les langues disponibles
LD-5010
11
Soap Installation
A
Attach soap supply tube from the
WashBar to the top of the soap pump.
B
Attach soap pump with supply tubes
attached into gallon jug.
Slide gallon jug with soap pump into
soap motor control box. Ensure soap
pump flange is positioned below motor
C
control box lever and soap control
box flange is positioned in soap pump
groove. Gallon jug should rest on soap
container bracket without soap pump
pulling off of container.
Use the hook and loop strap provided
to secure container to soap bracket.
D
Feed end of cable tie (smooth side
facing you) through the right side slot
of bracket flange at top. Feed through
left side flange slot and wrap around
jug. Secure with hook and loop end.
Ensure that the soap tube is not
F
kinked. Position hand above soap
motor control box and adjust tube if
needed.
G
To manually prime the soap, press
down on the control box lever arm 6
to 8 times.
For ease of soap container
removal, pull tank while rotating
bottom of tank out.
20
Top Flange
Cable Tie Slot
11/21/2019
The soap system is designed to be used with a standard
U.S. gallon soap container. For accurate low soap
indication, user needs to set soap type (see configuration
mode at the end of this manual on how to set soap type).
Soap cycle count defaults to liquid soap configuration. If
you have the foam soap option, please see Setting the
Soap Type under Configuration Mode towards the end of
this manual.
Bradley • 215-1869 Rev. E: ECO 19-11-006
Installation
Attach Soap Supply Tube Here
Soap Pump
Ensure Soap Pump
Flange is Positioned
Below Control Box Lever
Control Box
Flange
Soap Pump
Groove
Hook and Loop Strap
Soap Container
Bracket
Publicité
