Igloo ICEB26RR Instructions Et Recettes page 40

Troubleshooting
Problem
The cold water is not
cold.
The hot water is not hot.
The dispenser is noisy.
The bottle is leaking.
The dispenser is not
dispensing water.
Care and Maintenance
• Keep this dispenser in a dry and cool place and avoid direct sunshine.
Ensure the back of the dispenser is at least 20 cm (8 in.) away from the wall.
•
Never put the dispenser on paper or foam, which may store water and then cause creepage. Never put anything
•
flammable beside this machine.
Do not use the dispenser outdoors or in a place that can be splashed by water.
•
• If the dispenser is not in use for longer than a 24-hour period, turn off the heating switch or the refrigerating
switch to save power and drain any remaining water.
Clean your cabinet, controls, bottle probe and spout each time you change your water bottle. Use a clean soft
•
cloth and a food grade sanitizer or bleach.
Empty and clean the drip tray, grid and float as needed.
•
Solution
• It takes up to one hour after setup to dispense cold water.
• Make sure the power cord is properly connected to a working
outlet.
• Make sure the back of the dispenser is at least 20 cm from a wall
and there is free airflow on all 20 cm sides of the dispenser.
• Make sure green power switch on back of dispenser is On.
• If water still isn't cold, call customer service at +1 844-257-4103 for
assistance.
• It takes 15-20 minutes after setup to dispense hot water.
• Make sure the power cord is properly connected to a working
outlet.
• Make sure red power switch on back of dispenser is On.
• Ensure the dispenser is located on a level surface.
• The heating tube may be generating a slight noise. This is normal.
• Ensure the bottle is installed correctly.
• Check to see if the bottle is cracked or broken. If so, replace the
bottle.
• Check to see if the bottle is empty and replace with a new bottle if
necessary.
• There may still be air in the tank. Press and hold the water taps to
remove air until water begins to flow.
8