Publicité
Les langues disponibles
Les langues disponibles
Operation
IMPORTANT:
This unit has been tested and sanitized prior to packing and shipping. During transit, dust and
odors can accumulate in the tank and lines. Dispense and dispose at least one quart of water
prior to drinking any water.
Turn the Dispenser On/Off
IMPORTANT:
Before you turn the dispenser on and activate the hot and cold switches, ensure a bottle is
installed.
1 .
Plug in the dispenser and turn the On/Off switch to On.
2 .
Run water through the cold and hot water taps until water begins to dispense.
3 .
To power on the cooling system, flip the cooling switch to the On position.
4 .
To power on the heating system, flip the heating switch to the On position.
Dispense Cold Water
NOTE:
Water will take approximately 1 hour after plugging in and turning on to become completely chilled. The
cooling light will turn off once the water has been fully chilled.
1 .
Press a drinking glass or container against the cold water faucet to dispense cold water.
2 .
Release when your container is full.
Dispense Hot Water and Activate Child Safety Lock
CAUTION:
This unit dispenses water at temperatures that can cause severe burns. Avoid direct contact with hot
water. Keep children and pets away from the unit while dispensing. Never allow children to dispense
hot water without proper and direct supervision. Disable the heating feature by switching the heating
convenience switch to the Off position.
NOTE:
Water will take approximately 15-20 minutes after plugging in and turning on to reach its hottest
temperature. The heating light will turn off once the water has been fully heated.
1 .
This water dispenser is equipped with a child safety feature in order to prevent inadvertent dispensing. To
enable dispensing of hot water, press and hold the red lock button and then press your mug or container
against the paddle directly beneath the red lock button.
2 .
Release the paddle once your container is full.
Change the Water Bottle
CAUTION:
Do not dispense hot, cool or cold water if the red light is flashing as you could empty the tanks and
cause the dispenser to overheat.
When the bottle indicator light on the front-right of the dispenser flashes red, it is time to replace your empty water
bottle with a new water bottle:
1 .
Open the dispenser cabinet door and slide the empty bottle out of the cabinet.
2 .
Remove the bottle adapter from the empty bottle and let the probe drip into the bottle. Once dripping has
stopped, place the bottle adapter on the hanger and set the empty bottle aside.
3 .
Follow the steps in Connect a Water Bottle to install your new water bottle.
4 .
Recycle the empty bottle at your local exchange center to receive your next bottle at a discount.
7
Publicité
