Hilti SF 8H-A22 Notice Originale page 29

All manuals and user guides at all-guides.com
den wiring or its own cord. Fasteners contacting a "live" wire
may make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
j) If the battery gets too hot to touch, this may indicate that it
is faulty. Place the tool in a location where it can be kept
under observation, well away from flammable materials,
and allow it to cool down. Contact Hilti Service after the
battery has been allowed to cool.
5.4.4 Electrical safety
Before beginning work, check the working area (e.g. using a
metal detector) to ensure that no concealed electric cables or
gas and water pipes are present. External metal parts of the
power tool may become live, for example, when an electric cable
is damaged accidentally. This presents a serious risk of electric
shock.
5.4.5 Work area
a) Ensure that the workplace is well lit.
b) Ensure that the workplace is well ventilated. Exposure to
dust at a poorly ventilated workplace may result in damage to
the health.
5.4.6 Personal protective equipment
The user and any other persons in the vicinity must wear
suitable eye protection, a hard hat, ear protection, protective
gloves and breathing protection while the tool is in use.
6 Before use
6.1 Battery use and care
NOTE
Battery performance drops at low temperatures. Use a battery
only when it has been fully charged. This ensures that maximum
battery capacity is available. Change to the second battery as
soon as a drop in performance is noticed. Recharge the battery
immediately so that it is ready for reuse.
Store the battery in a cool, dry place. Never store the battery
where it is exposed to direct sunlight or sources of heat, e.g. on
heaters / radiators or behind a motor vehicle windscreen. Batteries
that have reached the end of their life must be disposed of safely
and correctly to avoid environmental pollution.
6.2 Charging the battery
DANGER
Use only the Hilti batteries and Hilti chargers listed under
"Accessories".
Printed: 14.11.2013 | Doc-Nr: PUB / 5161651 / 000 / 00
en
25