Publicité
Les langues disponibles
Les langues disponibles
TO INSTALL NEEDLE
1.
Slide needle guard over needle. (See Figure 1)
2. Put needle lock lever in unlocked position
(lever pointed to front of tool). (See Figure 2)
3. Place tool so lock lever faces away from you.
4. Insert needle by aligning side slot on needle with
guide slot on tool.
5. Turn needle lock lever to locked position
(lever pointed to back of tool). (See Figure 2)
6. Remove needle guard.
TO REMOVE NEEDLE
1.
Slide needle guard over needle.
2. Put needle lock lever in unlocked position (lever
pointed to front of tool). (See Figure 2)
3. Slide the needle out of the tool.
4. Dispose of needle in a Biohazard Sharps container.
NOTE: For contaminated needles, see safety
instructions on page 1.
TO LOAD FASTENERS
1.
Insert the end of the round connecting bar on the
fastener clip into the round guide slot at the top of
the tool. (See Figure 1)
2. Gently push the fastener clip into the guide as far as
it will go. Tool is ready for use.
TO REMOVE A PARTIALLY USED CLIP
1.
Fully depress the trigger and remove the clip by
pulling upward.
NOTE: Always depress the trigger when
removing a clip of fasteners from the tool.
Failure to do so may cause the tool to jam.
PAGE 2 OF 6
INSTALLING AND REMOVING NEEDLES
LOADING AND ATTACHING FASTENERS
1-800-295-5510
Figure 1
Figure 2
Locked Position
TO ATTACH FASTENERS
1.
Insert the needle through the hole in the tag.
2. Insert the needle through the garment.
3. Hold the material firmly against the front of the tool
and squeeze the trigger.
4. Release the trigger.
5. Withdraw the needle and tool from the garment.
uline.com
Guide
Slot
Needle
Lock Lever
Needle
Trigger
Needle
Guard
Unlocked Position
0524 IH-863
Publicité
