CUTRA CtrlAX Manuel D'instructions page 23

Information on blades and blade fixtures
Regarding the blade and the blade
fixture
1. Use the provided blade and the set screw.
* Make sure the blade and the set screw are securely fastened before use.
2. Stains on the blade or blade fixture can cause overheating, noise, and product damage.
* Before use, check for stains on the blade and blade fixture and replace them if there are any stains.
3. If a set screw other than the provided by our company is used for fastening,
it may not properly tighten and thus may not work properly.
- Using blades other than provided or having a loose set screw may cause the machine
to malfunction, affecting the cutting force and posing a risk of damage or falling
- If the blade is not tightened properly, a warning beep will sound and the operation
- Make sure the blade and blade fixture is inserted all the way in and tighten the
Regarding the blade and the blade
fixture
- Replace it before the set screw gets worn out.
- If the worn bolt cannot be removed, contact the manufacturer or distributor.
- If you replace the blade while the oscillator is hot, the set screw may become loose when
- Check if the set screw is tightened before use. If it is loose, tighten it again before use.
When replacing the blade fixture
out of the blade, which can be very dangerous.
hex bolt firmly with a torque wrench.
- Ensure that the set screw is tightly fastened.
- Please replace the wrench tip with a new one if it is worn.
button will not work.
Finally
the oscillator cools down.