Replacing blade and the blade fixture
1. Turn off the power and remove the blade by loosening the set screw.
2. Place the new blade in the concave part of the blade fixture. Do not assemble the blade and
set screw diagonally
3. Tighten the set screw until it makes a "click" sound with a torque wrench.
4. After ensuring that the blade is tightened, turn
on the main power and press the operation
button to see if it works normally
View after assembly is complete
Blade
Precautions for replacing blade and the blade fixture
- Turn off the power of the device.
- If the blade or the blade fixture is
contaminated or damaged, such as being
blackened, remove the contaminants or
replace them with new ones.
- If it is not working properly, wipe the
oscillator with a cotton swab.
(After cleaning it with alcohol, make sure it is
fully dried before assembly.)
Blade fixture
- Use a torque wrench to tighten the set screw.
- Be careful not to get injured when handling
the blade.
- Be careful because the blade, collet, mountain
bolt, and the oscillator are very hot right after
use because of the frictional heat generated
by ultrasonic vibration. (After cleaning it with
alcohol, make sure it is
fully dried before assembly.) using CtrlAX.
Components
Set screw
Oscillator