CUTRA CtrlAX Manuel D'instructions page 21

Precautions for use
Check if the blade is
Properly attached to the handpiece
Precautions before use
- CtrlAX cuts better than regular knives.
Handpiece with care.
- Make sure the provided power adapter
Is properly connected.
- Wear appropriate clothing for the job.
- Always turn off the power button and attach
the handpiece to the main body when not
using CtrlAX.
Precautions when there is a beep sound
Overheating symptoms
When the temperature of the oscillator rises,
There will be a long beep sound once,
And the power will be turned off.
It will switch to a standby mode for 3 minutes due
To overheating. After 3 minutes,
Ther will be a long signal sound once more.
Pre-use checks and precautions
Ensure that the set screw is
Tightly fastened for safety
- Secure the workpiece firmly during use.
- This product cannot be used on
metals or glass.
- Harmful gases may be generated during
Cutting depending on the material being cut.
Wear a protective mask and ensure adequate
ventilation.
Overcurrent symptoms
The device will make two beep sounds
And stop it's performance in the
Following situations.
1. When cutting hard objects such as
Metal or glass.
2. When the blade is stuck in a hard object.
3. When excessive force is applied during cutting.
Please wear safety glasses, gloves,
And other necessary protective gears
Blade non-detection symptoms
If the following situations occur,
A signal sound will be emitted 3 times
And the power will be turned off
1. When the blade is not attached.
2. When the set screw is not tightened properly.