Cleaning & Maintenance - Honeywell MN10CCS Mode D'emploi

CLEANING & MAINTENANCE
Appliance Maintenance:
1. Turn off the appliance before disconnecting the power supply.
2. Only clean the appliance with a soft dry cloth.
Dust Filter Maintenance:
The dust filter is to be cleaned every two weeks to maintain
air cooling efficiency. Please follow the below instructions for
cleaning the dust filter:
1. Switch off and unplug the air conditioner from
the electrical outlet.
2 . Remove the Upper Dust Filter and the Lower Dust Filter.
3 . Gently wash using water and/ or diluted liquid dishwashing
detergent.
Rinse thoroughly and gently shake excess water from
the filters. Make sure the filters are dry before reinstalling.
Note: You may use a vacuum cleaner to remove dust.
4. Replace the Upper Grill and the Lower Grill onto the unit.
WARNING: DO NOT power or operate the Air Conditioner when cleaning or when the Dust Filter is
removed from the unit, or if there is a loose-fitting Dust Filter. DO NOT attempt to handle or touch
any of the parts or wiring inside the Rear Grill after the Dust Filter has been removed from the unit.
Doing so can cause serious injury or electrical shock.
End of Season Storage & Maintenance:
If the appliance will not be used for a long time, follow these steps:
1. Be sure to drain the left-over water condensation. Remove the lower drain plug and use a
shallow pan to collect the water (make sure to replace the drain plug when finished).
2. To dry excess moisture, run the unit in Fan only mode for 30 minutes before storing.
3. Turn off and unplug the air conditioner from the power supply.
4. Remove the dust filter and clean with water. Dry the dust filter and then reinstall.
EN 11
Upper
Dust Filter
Rear Grill