Maintenance; Troubleshooting; Installation - iComfort ic7500 Manuel D'utilisation

3. MAINTENANCE

• This product should only be maintained by iComfort® certified technicians. Otherwise, EBI reserves the right
to void the warranty.
• Disconnect the power cord after if you do not plan to use the chair for a long period.
• Make sure the wall outlet is in good working order before use.
• If this chair will not be used for an extended period, store in a dry and dustless environment.
• Avoid chair exposure to high temperatures and direct sunlight.
• Clean this product with a dry cloth. Do not use thinner, benzene or alcohol.
• When moving the chair on a wood floor, rough ground or in a narrow space two people should lift the chair
together.
• We recommend using the massage chair intermittently and not for long periods.

4. TROUBLESHOOTING

• It is normal for the motor to make noise while in use.
• If the controller doesn't normally work, please check that the plug and socket are properly connected, and
the switch is turned on.
• When the programmed working time is over, the chair will power off automatically.
• After several uses, the chair might power off because of overheating. It can be used again after half an hour
of cooling time.

5. INSTALLATION

The ic7500 massage chair comes partly assembled.
• Assemble this massage chair according to the installation instructions provided in this guide.
• Check the parts list carefully to make sure nothing is missing.
• Sitting in the massage chair before it is completely assembled could result in permanent damage to
the chair and personal injury.
• This massage
plugged into an appropriate AC wall outlet.
• If the massage chair
unplug the AC power cord. You can unscrew the fuse located in the switch box at the bottom right of
the chair in the back.
Use a same size and type of fuse to replace the old one and then cover the lid.
You can call iComfort® at 1-866-967-7333 ext 227 if you need help.
CAUTION: Never substitute a missing part with one of your own. If a part is missing, contact customer
service at: 1-866-967-7333 ext 227
Unpacking
Remove the massage chair, cushions and accessories from the main box.
Remove all plastic wraps.
Leg and foot massager linkage pole installation
For the leg massager to be able to incline and recline, you must install the leg massager linkage pole
correctly.
1) After connecting the connector and the air tube between the chair seat and the leg rest, unfasten
the linkage pole and insert the connecting part into the seat frame (1). Place the linkage rod from
the leg rest left and right sides to the leg's linkage pole support brackets (2).
chair is equipped with a cord having a grounding conductor. The cord must be
fuse is burned out, please use the chair's main On/Off button to turn it off and