Publicité
Les langues disponibles
Les langues disponibles
Low Flame Adjustment
DANGER
Lighting gas burners with a match is dangerous.
You should match light the cooktop burners only In an
emergency.
Light a match and hold the flame near the burner you
want to light. Wooden matches work best.
Push in and turn the control knob slowly. Be sure you are
turning the correct knob for the burner you are lighting.
NOTE: If the burner does not light within five seconds, turn
the knob off and wait one minute before trying
again.
WARNING
If you attempt to measure the inner cone of the flame,
please use caution.
Burns could result.
This appliance is shipped from the factory with low and
medium flame settings adjusted.
If further adjustment is necessary, proceed as follows:
Adjustment for Burners with one:
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
3. Insert a slender, thin-blade screwdriver into the recess
at centre of valve stem and engage blade with slot in
adjusting screw.
4. Turn center stem adjusting screw to set flame size:
• clockwise to reduce
• counterclockwise to increase
5. Replace control knob when adjustment is completed.
LOW FLAME ADJUSTMENT - SINGLE FLAME BURNER
Adjustment for Burners with two rings flame:
1. Light burner and set control knob for low flame.
2. Remove the control knob from valve stem. And also
remove the control panel, and valve gaskets.
3. Insert a slender, thin-blade screwdriver into the recess
and engage blade with slot in adjusting screw.
4. Turn center stem adjusting screw to set flame size:
• clockwise to reduce
• counterclockwise to increase
5. Replace control panel and knob when adjustment is
completed.
LOW FLAME ADJUSTMENT - CENTRAL DUAL FLAME BURNER
NOTE: There is no low flame adjustment on Stacked Burner.
EN
19
Publicité
